Straight answers and careful work on metal roof installation in Entiat, WA. Metal roofing is our specialty, but we do the whole roof.
We have been setting metal panels on houses, churches, barns and additions for over twenty years, and the crews serving Entiat install them the same way we always have. Straight lines, correct fastener spacing, and closures at the ridge so wind driven rain has nowhere to go.
When a Entiat homeowner calls us about metal roof installation, the first thing we do is come look. Somebody from the crew gets on the roof, checks the decking, flashing and fasteners, and works out what the job actually needs before a number is ever written down.
You get a written estimate for the metal roof installation on your Entiat home with the materials named and the price broken out, and that estimate is free. If we find something once the work starts, we stop, show you, and price it before we go any further.
What to expect once you call us out to look at your roof.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
If the shingles are coming off, they come off, and every board underneath gets checked before anything new goes down.
We keep panels straight to a line rather than to the eye, because a metal roof shows every bit of drift the moment the sun hits it.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
Straight answers, no sales talk.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Entiat homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Most Entiat metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Installed properly over sound decking, a metal roof should give a Entiat home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Entiat house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Our reputation is just the roofs behind us.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Our church needed a new roof and the budget was tight. They worked with us on it, did beautiful work, and finished before the fall revival."